Measuring transmitter TK-6

Measurement and conversion of electrical signals generated by thermocouples, RTDs, bridge transducers, sensors with DC-current output.
Three-wire or four-wire RTD connection.
Transfer measurement results over RS-485 interface, protocol Modbus (RTU).
Device conversion function – linear or square-root extracting.
Cold junction temperature compensation (internal sensor).
The possibility to receive the cold junction temperature from the external meter over RS-485 interface, Modbus protocol (RTU).
The configurable analog input.
Continuous sensor fault detection.
LED indication of operating modes.
Installation on DIN rail, 35 mm.

Thermocouples	K, L, S, B
RTDs: platinum (W₁₀₀=1.3850 и W₁₀₀=1.3910) copper (W₁₀₀=1.4260 и W₁₀₀=1.4280)	Pt50, Pt100, Pt500 Cu50, Cu100
DC-current input signal range, mA	0..5; 0..20; 4..20
Bridge transducer input signal range, mV	0..90
Temperature measurement error (for thermocouples), °С: L, K in the range of -150..0°С L, K in the range of 0..800 (1300)°С S B	±(0.25·10^-2×\|t\|+0.5) ±(0.1·10^-2×\|t\|+0.5) ±5.0* ±7.0
Temperature measurement error (for RTDs), °С	±(0.2·10^-2·(t+273)+0.1)
Reduced DC-current signal measurement error, %: for input signal range 0..5 mА for input signal range 0..20, 4..20 mА	±0.5 ±0.25
Reduced bridge transducer signal measurement error, %	±0.5
Baud rate, Kbps	9.6; 19.2; 38.4
Supply voltage	(14..32)VDC/(14..22)VAC 50Hz
Operating temperature range	+5°С..+50°С
Protection type (IP code)	IP20
Size (W×H×D), mm	17,8×85×58

* – when internal sensor is used for cold junction temperature compensation it should be added 2.0 °С to error value

Measuring transmitter TK-6.