Measuring transmitter PR-01-TK

Continuous measurement three-phase network without neutral parameters: currents and voltages on two phases, active, reactive, and total power, power factor.
Programmatically setting up nominal current on measuring inputs.
Active, reactive, total power and power factor calculation by two wattmeters method.
Two galvanic isolated unified current outputs.
Nominal current value programmatically setting up for each current output.
RS-485 interface, Modbus RTU protocol.
Setting up via control unit PN-01-TK or special software via RS-485 interface.

Nominal input values: voltage, V current, A	100 0.5; 1; 2.5; 5
Measured values limits: voltage lower bound, V voltage upper bound, V current lover bound, A current upper bound, A	80 120 0,01×I 1,2×I
Unified current output ranges, mA	-5..0..5; 0..2,5..5; 0..5; 0..20; 4..20
Measured value to digital signal transformation reduced error, %, up to	±0,5
Measured value to current output transformation reduced error, %, up to: for 0..20, 4..20 mA ranges for 0..5, -5..0..5, 0..2,5..5 mA ranges	±0,5 ±1,0
Baud rate, kbps	9.6; 19.2; 38.4; 57.6; 115.2
Power supply	(70..300)VAC / (50..250)VDC 24VDC
Operating temperature range	+5°С..+50°С
Dust and moisture protection	IP40
Overall dimensions (W×H×D), mm	125×60×200

Measuring transmitter PR-01-TK-XXХ–Y, where
ХXХ – power supply:

«24V» – 24VDC;

«220V» – (70..300) VDC; (50.. 250) VAC 50 Hz.

Y – modification:

«U» – modification without current outputs;

no marking – modification with current outputs.