Measuring transmitter PR-03-TK

Continuous measurement three-phase network with neutral parameters.
Программное задание номинального значения тока на измерительных входах.
Active, reactive, total power and power factor calculation by three wattmeters method.
Transferring results via RS-485 interface (protocol Modbus RTU), and converting to two unified current outputs.
Nominal current value programmatically setting up for each current output.
RS-485 interface, Modbus RTU protocol.
Setting up via control unit PN-01-TK or special software via RS-485 interface.

Nominal input values: voltage U_nom, V current I_nom, A	100/√3 0,5; 1; 2,5; 5
Measured values limits: voltage lower bound, V voltage upper bound, V current lover bound, A current upper bound, A	80/√3 120/√3 0,01×I_nom 1,2×I_nom
Unified current output ranges, mA	-5..0..5; 0..2,5..5; 0..5; 0..20; 4..20
Measured value to digital signal transformation reduced error, %, up to	±0.5
Measured value to current output transformation reduced error, %, up to: for 0..20, 4..20 mA ranges 0..5, -5..0..5, 0..2.5..5 mA ranges	±0.5 ±1.0
Baud rate, kbps	9.6; 19.2; 38.4; 57.6; 115.2
Power supply	(70..300)VDC/(50..250)VAC 24VDC
Operating temperature range	+5°С..+50°С
Dust and moisture protection	IP40
Overall dimensions (W×H×D), mm	125×60×200

Measuring transmitter PR-03-TK-XXХ–Y, where
ХXХ – power supply:

«24V» – 24VDC;

«220V» – (70..300) VDC; (50.. 250)VAC 50Hz.

Y – modification:

«U» – modification without current outputs;

no marking – modification with current outputs.